How to record Motown-influenced soul vocals
27th Apr 2011 | 10:43
In the early days of Motown Records, when the label was striving to define a classic sound for soul music, Berry Gordy’s engineers ran into a problem. They couldn’t get their vocals to stand out in the mix.
Unlike a lot of music around at the time, those early soul productions had the instrumentation cranked up loud, which meant that the vocals had to fight very hard to compete. The engineers applied plenty of compression and EQ to make them sound bigger, but the early recordings felt like they had the life sucked out of them.
With no dynamics, they just weren’t as good as they could be. And at a label where songs routinely went through upwards of 20 different mixes to get them sounding as clear as possible, that just wouldn’t do.
Enter Lawrence Horn. Now serving a life sentence for three murders, he was once one of the best mix engineers at Motown. He came up with a technique that managed to lift the vocals up and make them powerful and bright, while still retaining their dynamics.
Parallel compression was still some years away from being invented, but Horn’s technique, which we illustrate below, uses the same principle: combining a compressed signal with an uncompressed one to get a fantastic combined sound.
Although production styles have moved on since the days of Motown, this is a technique that’s still used in mixing soul music today. It’s a very straightforward method to put into practice, and if you create a mixer template for it, you’ll find that sticking it on your soul vocals becomes second nature.
Step 1: First things first: double up your vocal. You can use two different takes or simply duplicate the same one. In this case, we duplicate Ilana’s voice, without adding any effects just yet. This technique can work just as well with a single vocal sent to an auxiliary track, but we’ve opted for doubling here.
EQ channel one
Step 2: On the first channel, add some reverb and a bit of EQ. Neither has to be particularly heavy: wet the vocal with some comfortable reverb and apply a subtle boost around the 5kHz region, with possibly a little bit of low cut as well.
EQ and compress channel two
Step 3: The key is the second vocal channel. Compress this heavily, using a high Ratio, low Threshold and medium Attack and Release settings. Next, really push the EQ: anything over 5dB at 5kHz will do. You can also roll off anything over 12kHz.
Mix the two channels
Step 4: Set the first vocal channel at a comfortable level, and slowly bring up the second. You should end up with a sound that’s bright, full and clear, and will cut through any mix of instrumentation you throw it at. Getting this to sound natural is quite easy: you’ll hear if you push the level too far.
Warm it all up
Step 5: It also helps to run your vocals through a saturation plug-in to colour the sound even more. We’ve gone for SoundToys’ Decapitator here because it has a setting (A) that models a tape drive used at both Stax Records and Chess Records’ studios. However, any similar saturation plug-in will do.