How to mix a track with headphones

23rd Apr 2013 | 15:29

How to mix a track with headphones
How to judge your mix on headphones

There are many differences between experiencing a track on speakers and on headphones.

If you only ever use headphones for mixing, it’s all too easy to misjudge your mixes. Common mistakes include making the stereo field too narrow, and not splashing enough reverb onto vocals and synth parts, leaving them overly dry. Judging how much of any effect to use should be a decision that’s made through listening on both cans and monitors.

A well produced track should sound great on everything from laptop speakers to a high-end hi-fi. Don’t forget: just because you can mix on headphones doesn’t necessarily mean that you should.

That said, there are techniques that can help you mix more accurately when using just a sat of cans. On the next few slides we’ll guide you step-by-step through the process of mixing a track without using monitors.

For loads more on working on headphone check out the May issue of Computer Music (CM 190) which is on sale now.

Step 1: We’re using some stems from a piano-led alternative pop track and have dropped them into our DAW. The track sounds pretty good in our headphones but we’ll need to make some adjustments so that it both translates well over a monitor setup and has a bit more depth and detail for those listening on cans.

Listen: raw track stems

How to mix a track with headphones
Widening the stereo field

Step 2: To make the FX track stand out more in the mix, we use Brainworx BX Solo to widen the stereo field to 200% and drop the volume by -3dB. We use BX Solo again on the bassline but this time narrow the width to mono. We also add an instance of Waves MaxxBass to generate harmonics of the bassline, giving us an audible impression of the thump of the low end, even though we can’t feel it.

Listen: wider FX

How to mix a track with headphones
Adding delay

Step 3: The arpeggio track will sound fine over monitors but is a little too sterile in our headphones. We give it some subtle ping-pong delay with KR-Delay CM’s Delay set to 1/16 and the Dry/wet at 15%. Although this effect won’t be noticed much when heard on speakers, it helps to make the whole track sound less dry for those listening on ’phones.

Listen: delay on the arpeggio

How to mix a track with headphones
Emphasising parts with gain

Step 4: The chords and notes of the piano line are easy to pick out using our cans. However, we’ll need to make it sound more in-your-face over speakers. Instead of turning it up, we give it +8dB Gain using console channel emulator Satson CM. We drop the track’s level to -8dB to compensate for this. We also increase Satson CM’s High pass to 200Hz to stop the piano clashing with the bass and kick.

Listen: piano with Satson CM

How to mix a track with headphones
Adding reverb

Step 5: For the same reason that we added a little depth to the arpeggio line with some delay, we’re going to give the whole mix some reverb. This will help things gel together over headphones and give some extra depth. We use Reverberate CM’s Close Drum Room preset and turn the IR Gain down to -30dB so that we get just some subtle reverb feedback.

Listen: full track with light reverb

How to mix a track with headphones
Matching EQ

Step 6: It’s hard to tell if our track is EQ’ed well using just headphones, so we’re going to match the EQ from a commercial track. Houdini by Foster The People has a similar kind of vibe, so we’re using that as a reference. Using Ozone 5’s Equalizer, we take ten-second snapshots of our own track and Houdini and hit the Match button. We adjust the Amount and Smooth sliders as pictured.

Listen: full track with matched EQ

Share this Article

Most Popular

Edition: UK
TopView classic version