How to make a Noisia Diplodocus-style old-skool bass sound

24th Sep 2009 | 15:26

How to make a Noisia Diplodocus-style old-skool bass sound
Getting started

Step 1:Diplodocus uses an assortment of different bass sounds, but we can approximate their synthesis techniques to build something of the same ilk. We’re going to use LinPlug’s Albino 3 (click here to download a demo) to create some low, gritty textures, then filter them into thoroughly obnoxious phrases.

How to make a Noisia Diplodocus-style old-skool bass sound
Initialising the synth

Step 2: Start by initialising Albino. You’ll find the patch z_initial at the bottom of the Diverse Sounds category (download it by right-clicking here if you’re using the demo version). You might also want to reduce the Velocity knob on the right-hand side of the interface and zero the Envelope amount on Filter 1.

How to make a Noisia Diplodocus-style old-skool bass sound
Pulse width modulation

Step 3: In the master section, set Precision to 100. Also, adjust Osc 1’s Waveform to square. Then, change the first Mod Matrix destination to Osc 1 Symmetry and turn the amount up to about halfway. This creates pulse width modulation, giving the sound a gritty edge.

How to make a Noisia Diplodocus-style old-skool bass sound
Oscillator 3

Step 4: Activate Osc 3, set it to Digital with a triangle Waveform (drag the slider beneath the waveform, so that it’s not mixed with any sine). Reduce the Release in the Amplitude Env section. Slow LFO1’s Frequency down to about 2.

How to make a Noisia Diplodocus-style old-skool bass sound
Oscillator 4

Step 5: Set Osc 4 to an Analog square Waveform, then activate it. Detune it by -7 Semitones, +3 Octaves, and switch on Sync so that it locks to the pitch of Osc 3. In the Mod Matrix, assign LFO 2 to Osc 4 Symmetry and push the amount up to the maximum, for even more dirt.

How to make a Noisia Diplodocus-style old-skool bass sound
More tweaks

Step 6: Select L2 in the Quad LFO section and set its Frequency to about 8. Turn Osc 4’s Volume down to about halfway. Adjust Filter 1’s type to BP and make sure its Mode is set to 24. Also, switch on Filter 2.

How to make a Noisia Diplodocus-style old-skool bass sound
Finishing the sound

Step 7: Activate Osc 2 as a Digital Sine waveform. Click F2 to send Osc 2 through Filter 2. Turn Filter 1’s Cutoff down to about 150 and its Resonance to about 20. In the Mod Matrix, add the Modulation Wheel to control Fil 1 Cutoff by about half.

How to make a Noisia Diplodocus-style old-skool bass sound
MIDI editing

Step 8: In your sequencer’s MIDI editor, program a pattern of a few low notes, then have some fun recording sweeping mod wheel patterns. If you don’t have a MIDI keyboard, use the mouse to draw in some wacky shapes.

Share this Article
Google+

Most Popular

Edition: UK
TopView classic version