9 pro mastering tips for beginners

24th Nov 2009 | 14:29

9 pro mastering tips for beginners
Try an exciter/ enhancer

Mastering is often considered to be something of a dark art, being the final, complicated process that a track goes through before it’s considered to be finished. However, it isn’t an unlearnable skill; Computer Music has a beginners’ guide to mastering in its December issue (CM146), and offers the following nine tips on the subject.

Tip 1: If your top-end still isn’t right despite your best EQ efforts, you might want to try an exciter or enhancer. Whereas EQs can accentuate noise, and only amplify what’s already there. Exciters raise the harmonics of the fundamental tones found in the recording, brightening dull mixes. As with everything in mastering, though, don’t overdo it!

9 pro mastering tips for beginners
Narrow the mix

Tip 2: Adjusting the width of a stereo recording usually means making it wider, but an overly wide mix can be narrowed, too. There are plug-ins that can do this, but they need to be handled with care, as they can cause phasing issues and weaken a tough mix. Be sure to leave everything below 100Hz alone, as this area carries no directional information and has a much greater impact in mono than stereo.

9 pro mastering tips for beginners
Noise reduction

Tip 3: You might want to apply noise reduction at times, especially during long fade-ins or -outs. This can be necessary because of bad recording or a number of other factors. Inevitably, though, unless you have very high-end equipment, noise reduction will affect the harmonic content of the music to some extent, so there’ll need to be some measure of compromise.

9 pro mastering tips for beginners
Expand the dynamic range

Tip 4: Expansion can be useful for pulling some dynamics out of a squashed mix. Expanders work in almost the exact opposite way to compressors, increasing dynamic range rather than compressing it. They can’t perform miracles, though, and can in fact add distortion, so if you have to rely on one, perhaps you should think about having another go at the mix.

9 pro mastering tips for beginners
Don't go through the ceiling

Tip 5: Keep your limiter’s output (sometimes called the ‘ceiling’) under 0dB. Although you might want your track to be as loud as possible, some CD players can glitch if too many samples hit 0dB, and some disc duplication plants may reject the disc because their equipment determines the 0dB samples to be ‘errors’. Set your limiter to -0.5dB or thereabouts.

9 pro mastering tips for beginners
Lookahead limiting

Tip 6: Some plug-in limiters offer a lookahead function. This can cut the beginning of your track off completely if your left locator (export start point) is set too close to a zero-crossing. So, if you use lookahead, leave a second or two lead-in and -out for the bounce, then tighten up the start and end of the final, mastered audio file.

9 pro mastering tips for beginners
Put songs on separate tracks

Tip 7: When mastering an EP or album, import all the songs onto separate audio tracks, so that each one can have its own EQ applied and the whole lot can be balanced accordingly. Route all of them to the same bus, then compress and limit them together for consistency.

9 pro mastering tips for beginners
Try mastering reverb

Tip 8: Very rarely, you might want to use a mastering reverb to ‘glue’ a mix together. Convolution is your best option here, but avoid plate/spring emulations and be gentle with the wet signal - no more than 10-15% - and roll off all the wet signal below 100Hz, too.

9 pro mastering tips for beginners
Don't overdo it

Tip 9: Last but not least - and at the necessary risk of repeating ourselves - don’t overdo anything! Big EQ boosts, high compression ratios and/or super-low thresholds can ruin a track. You can still be creative while being subtle. Be sure to keep an eye on your spectral analyser plug-in, ensure that the master channel never clips and learn to trust your ears. This is the final process in the production of your tune, so it really is now or never!

Share this Article

Most Popular

Edition: UK
TopView classic version